waterbycounty
EPA SDWIS

Stewart County Water Quality

Stewart County, Tennessee

Water Grade

F

Water Score

17.4

Violations

19

State Rank

#90

of 95 (1 = best)

EPA SDWIS Compliance

Drinking Water Quality

Water Quality Grade

F

Based on EPA compliance history and violation data

Water Score

17.4/100

Higher = better quality

Health Violations

19

Health-based violations

Violation Rate

159.2%

Systems with violations

Water Advisory: Stewart County

Water Verdict

Stewart County receives a poor water quality assessment with a grade of F and a score of 17.4 out of 100. The water supply has documented quality issues. Residents are strongly encouraged to use filtered or bottled water for drinking and to stay informed about utility improvement plans.

Violation Context

Stewart County has recorded 19 health-based violations, indicating multiple instances where federal contaminant limits or treatment requirements were not met. At 159.2 violations per 1,000 residents, this rate is high and signals significant water quality management issues.

Consumer Guidance

Residents of Stewart County are advised to use filtered or bottled water for drinking and cooking until water quality improves. A reverse-osmosis or activated-carbon filter certified to remove the contaminants listed in the utility's Consumer Confidence Report is recommended. With 19 recorded health violations, staying informed about utility communications and boil-water notices is especially important. For long-term peace of mind, request your utility's latest Consumer Confidence Report and consider independent water testing if you have specific health concerns.

Regional Context

Stewart County has poorer water quality than the average county in Tennessee. Its water score is 53.9 points lower than the state average, suggesting more challenges with contamination control or infrastructure than neighboring counties.

Clean Water Act §303(d)

Watershed Health

Impaired Water Bodies

3.3%

2 of 60 assessed

Mostly healthy

Top Impairment Causes

  • 1

    PHYSICAL SUBSTRATE HABITAT ALTERATIONS

  • 2

    ESCHERICHIA COLI (E. COLI)

Source: EPA ATTAINS · Reporting cycle 2022

Impairment is determined under the Clean Water Act §303(d): a water body is impaired when it fails to meet state-defined quality standards for designated uses (drinking, recreation, aquatic life). Assessment coverage varies by state — counties without assessed water bodies are not shown.

Past 5 years

Water Quality Monitoring

Monitoring Sites

16

Active in the past 5 years

Measurements Recorded

3.3K

3,298 total readings

Most Measured

  • Physical
  • Inorganics, Minor, Metals
  • Biological, Algae, Phytoplankton

Categories measured most frequently

Data from the EPA Water Quality Portal (WQP), aggregating monitoring records from federal, state, and tribal sources. Each measurement represents a single sample analyzed for a specific characteristic (e.g., E. coli, pH, dissolved oxygen, nitrogen).

Improve your water quality at home

Berkey filters remove 99.9%+ of contaminants from tap water.

Shop Berkey →

Sponsored

Test your tap water

Tap Score provides professional mail-in water testing.

Get Tested →

Frequently Asked Questions

What is the water quality in Stewart County, Tennessee?
Stewart County, Tennessee has a drinking-water quality grade of F with a score of 17.4/100, based on EPA SDWIS compliance data. The county has 19 health-based drinking water violations over the past 5 years. Watershed health, monitoring records, and live streamflow are reported separately on this page.
Are there any water violations in Stewart County?
Stewart County has 19 health-based drinking water violations recorded by the EPA over the past 5 years. Health-based violations indicate instances where contaminant levels exceeded EPA Maximum Contaminant Levels (MCLs). Violations may have been resolved — check with your local water utility for current status.
How healthy are the watersheds in Stewart County?
EPA ATTAINS assessments under Clean Water Act §303(d) indicate 3.3% of Stewart County's 60 assessed water bodies are classified as impaired (2 impaired). The top reported causes are PHYSICAL SUBSTRATE HABITAT ALTERATIONS, ESCHERICHIA COLI (E. COLI). Impairment means the water body fails to meet state quality standards for at least one designated use — drinking water source, recreation, aquatic life, or fish consumption. Note: watershed impairment doesn't always translate to tap-water issues; treatment plants can remove most regulated contaminants.
How much water-quality monitoring happens in Stewart County?
EPA's Water Quality Portal records 3,298 measurements from 16 monitoring sites in Stewart County over the past five years. The most frequently measured characteristic groups are Physical, Inorganics, Minor, Metals, Biological, Algae, Phytoplankton. Each measurement is a single sample analyzed for one characteristic (E. coli, pH, dissolved oxygen, etc.). High monitoring density means more scientific evidence behind any reported signal — it does not by itself indicate water quality.
How does Stewart County water compare to the Tennessee average?
Stewart County's SDWIS water quality score of 17.4/100 is lower than the Tennessee state average of 71.3. The average water quality grade across Tennessee is C, based on data from 95 counties with available SDWIS data.
Is tap water safe to drink in Stewart County?
Based on EPA SDWIS data, Stewart County has a water quality grade of F (17.4/100). This indicates below-average compliance with significant violations. Residents may want to consider home water filtration or independent testing. The grade speaks to the public water system, not the watershed — for watershed-level concerns, see the Watershed Health zone. For the most up-to-date information, contact your local water utility or review your Consumer Confidence Report (CCR).
Why does Stewart County have so many water violations?
Stewart County has 19 health-based drinking water violations on record from the EPA SDWIS database. A higher violation count can result from aging infrastructure, underfunded water utilities, agricultural runoff contamination, or industrial pollution. Counties with more water systems may also see more violations simply due to scale. Residents concerned about water quality should consider independent water testing and home filtration systems.
How does Stewart County rank for water quality in Tennessee?
Stewart County ranks #90 out of 95 counties in Tennessee by SDWIS water quality score (1 = best). With a score of 17.4/100, it falls in the bottom third of counties statewide. The ranking reflects EPA SDWIS compliance only — not watershed impairment, monitoring density, or streamflow, which are tracked separately on this page.

Counties with Similar Water Quality

Grundy County

Tennessee

F

17.0

Water score

Smith County

Tennessee

F

18.9

Water score

Trousdale County

Tennessee

F

15.5

Water score

Data Sources

Drinking-water compliance data from the EPA Safe Drinking Water Information System (SDWIS) via the ECHO enforcement database. Scores reflect compliance history and health-based violation counts.

Watershed health and impaired-waterway data from the EPA ATTAINS Clean Water Act §303(d) assessments — state-reported, EPA-finalized.

Water-quality monitoring counts from the EPA Water Quality Portal (WQP) — federated USGS, EPA, and state agency sampling records over a rolling 5-year window.

Disclaimer: This data is informational only. It is not health, legal, or professional advice. For concerns about your specific water supply, contact your local water utility.

By Logan Johnson, Founder & Data EditorUpdated Reviewed by Logan Johnson, Founder & Data Editor

Explore more data for Stewart County

Property TaxCost of LivingCrime RateIncomeHealthSchoolsDisaster RiskWeatherCounty Score