Hansford County Water Quality

Hansford County, Texas

Water Grade

D

Water Score

45.9

Violations

1

State Rank

#69

of 254 (1 = best)

EPA SDWIS Compliance

Drinking Water Quality

Water Quality Grade

D

Based on EPA compliance history and violation data

Water Score

45.9/100

Higher = better quality

Health Violations

1

Health-based violations

Violation Rate

22.5%

Systems with violations

Water Advisory: Hansford County

Water Verdict

Hansford County receives a below-average water quality assessment with a grade of D and a score of 45.9 out of 100. Residents should review their utility's Consumer Confidence Report and may want to consider additional water filtration for drinking.

Violation Context

Hansford County has recorded 1 health-based violation, meaning the water system experienced at least one exceedance of federal contaminant limits or treatment requirements. At 22.5 violations per 1,000 residents, this rate is high and signals significant water quality management issues.

Consumer Guidance

Residents of Hansford County are advised to use filtered or bottled water for drinking and cooking until water quality improves. A reverse-osmosis or activated-carbon filter certified to remove the contaminants listed in the utility's Consumer Confidence Report is recommended. With 1 recorded health violation, staying informed about utility communications and boil-water notices is especially important. For long-term peace of mind, request your utility's latest Consumer Confidence Report and consider independent water testing if you have specific health concerns.

Regional Context

Hansford County has better water quality than the average county in Texas. Its water score is 15.5 points higher than the state average, indicating stronger water system performance relative to neighboring counties.

Past 5 years

Water Quality Monitoring

Monitoring Sites

2

Active in the past 5 years

Measurements Recorded

130

130 total readings

Most Measured

  • Physical
  • Nutrient
  • Inorganics, Major, Non-metals

Categories measured most frequently

Data from the EPA Water Quality Portal (WQP), aggregating monitoring records from federal, state, and tribal sources. Each measurement represents a single sample analyzed for a specific characteristic (e.g., E. coli, pH, dissolved oxygen, nitrogen).

Live USGS Streamgage

River & Stream Conditions

Current Discharge

0.00cfs

May 14, 6:30 PM UTC

vs Long-Term Average

0%

Well below typical

Primary Streamgage

Palo Duro Ck nr Spearman, TX

USGS site
07233500
Drainage area
1,076 sq mi
Long-term mean
12.3 cfs

One representative streamgage (the one with the largest drainage area in the county). Many counties have multiple gauges — this view summarizes the primary one. The long-term mean is the full-record annual average; "% of typical" compares the latest reading against that average.

Improve your water quality at home

Berkey filters remove 99.9%+ of contaminants from tap water.

Shop Berkey →

Sponsored

Test your tap water

Tap Score provides professional mail-in water testing.

Get Tested →

Frequently Asked Questions

What is the water quality in Hansford County, Texas?
Hansford County, Texas has a drinking-water quality grade of D with a score of 45.9/100, based on EPA SDWIS compliance data. The county has 1 health-based drinking water violation over the past 5 years. Watershed health, monitoring records, and live streamflow are reported separately on this page.
Are there any water violations in Hansford County?
Hansford County has 1 health-based drinking water violation recorded by the EPA over the past 5 years. Health-based violations indicate instances where contaminant levels exceeded EPA Maximum Contaminant Levels (MCLs). Violations may have been resolved — check with your local water utility for current status.
How much water-quality monitoring happens in Hansford County?
EPA's Water Quality Portal records 130 measurements from 2 monitoring sites in Hansford County over the past five years. The most frequently measured characteristic groups are Physical, Nutrient, Inorganics, Major, Non-metals. Each measurement is a single sample analyzed for one characteristic (E. coli, pH, dissolved oxygen, etc.). High monitoring density means more scientific evidence behind any reported signal — it does not by itself indicate water quality.
What's happening with rivers in Hansford County right now?
Hansford County's primary USGS streamgage on the Palo Duro Ck is currently reading 0 cubic feet per second — 0% of the long-term mean of 12.26 cfs. This is well below typical — often a signal of drought stress on source water. For genuine real-time data, visit waterdata.usgs.gov.
How does Hansford County water compare to the Texas average?
Hansford County's SDWIS water quality score of 45.9/100 is higher than the Texas state average of 30.4. The average water quality grade across Texas is F, based on data from 254 counties with available SDWIS data.
Is tap water safe to drink in Hansford County?
Based on EPA SDWIS data, Hansford County has a water quality grade of D (45.9/100). This indicates below-average compliance with significant violations. Residents may want to consider home water filtration or independent testing. The grade speaks to the public water system, not the watershed — for watershed-level concerns, see the Watershed Health zone. For the most up-to-date information, contact your local water utility or review your Consumer Confidence Report (CCR).
Does Hansford County have clean drinking water?
Hansford County has 1 health-based drinking water violation according to EPA records. With a water quality score of 45.9/100 and grade D, the county's drinking water has had some compliance issues but continues to be monitored. Note: drinking-water compliance speaks to the public water system, not necessarily to the watershed itself — check the Watershed Health zone for ATTAINS §303(d) data.
How does Hansford County rank for water quality in Texas?
Hansford County ranks #69 out of 254 counties in Texas by SDWIS water quality score (1 = best). With a score of 45.9/100, it falls in the top third of counties statewide. The ranking reflects EPA SDWIS compliance only — not watershed impairment, monitoring density, or streamflow, which are tracked separately on this page.

Data Sources

Drinking-water compliance data from the EPA Safe Drinking Water Information System (SDWIS) via the ECHO enforcement database. Scores reflect compliance history and health-based violation counts.

Water-quality monitoring counts from the EPA Water Quality Portal (WQP) — federated USGS, EPA, and state agency sampling records over a rolling 5-year window.

Live streamflow from the USGS National Water Information System (NWIS) — continuous discharge measurements from the largest-drainage gauge in each county, compared against the full-record long-term annual mean.

Disclaimer: This data is informational only. It is not health, legal, or professional advice. For concerns about your specific water supply, contact your local water utility.

By Logan Johnson, Founder & Data EditorUpdated Reviewed by Logan Johnson, Founder & Data Editor