Hopkins County Water Quality

Hopkins County, Texas

Water Grade

D

Water Score

50.5

Violations

7

State Rank

#58

of 254 (1 = best)

EPA SDWIS Compliance

Drinking Water Quality

Water Quality Grade

D

Based on EPA compliance history and violation data

Water Score

50.5/100

Higher = better quality

Health Violations

7

Health-based violations

Violation Rate

15.7%

Systems with violations

Water Advisory: Hopkins County

Water Verdict

Hopkins County receives a below-average water quality assessment with a grade of D and a score of 50.5 out of 100. Residents should review their utility's Consumer Confidence Report and may want to consider additional water filtration for drinking.

Violation Context

Hopkins County has recorded 7 health-based violations, indicating multiple instances where federal contaminant limits or treatment requirements were not met. At 15.7 violations per 1,000 residents, this rate is high and signals significant water quality management issues.

Consumer Guidance

Residents of Hopkins County are advised to use filtered or bottled water for drinking and cooking until water quality improves. A reverse-osmosis or activated-carbon filter certified to remove the contaminants listed in the utility's Consumer Confidence Report is recommended. With 7 recorded health violations, staying informed about utility communications and boil-water notices is especially important. For long-term peace of mind, request your utility's latest Consumer Confidence Report and consider independent water testing if you have specific health concerns.

Regional Context

Hopkins County has better water quality than the average county in Texas. Its water score is 20.1 points higher than the state average, indicating stronger water system performance relative to neighboring counties.

Past 5 years

Water Quality Monitoring

Monitoring Sites

13

Active in the past 5 years

Measurements Recorded

9.0K

9,038 total readings

Most Measured

  • Physical
  • Inorganics, Major, Non-metals
  • Nutrient

Categories measured most frequently

Data from the EPA Water Quality Portal (WQP), aggregating monitoring records from federal, state, and tribal sources. Each measurement represents a single sample analyzed for a specific characteristic (e.g., E. coli, pH, dissolved oxygen, nitrogen).

Improve your water quality at home

Berkey filters remove 99.9%+ of contaminants from tap water.

Shop Berkey →

Sponsored

Test your tap water

Tap Score provides professional mail-in water testing.

Get Tested →

Frequently Asked Questions

What is the water quality in Hopkins County, Texas?
Hopkins County, Texas has a drinking-water quality grade of D with a score of 50.5/100, based on EPA SDWIS compliance data. The county has 7 health-based drinking water violations over the past 5 years. Watershed health, monitoring records, and live streamflow are reported separately on this page.
Are there any water violations in Hopkins County?
Hopkins County has 7 health-based drinking water violations recorded by the EPA over the past 5 years. Health-based violations indicate instances where contaminant levels exceeded EPA Maximum Contaminant Levels (MCLs). Violations may have been resolved — check with your local water utility for current status.
How much water-quality monitoring happens in Hopkins County?
EPA's Water Quality Portal records 9,038 measurements from 13 monitoring sites in Hopkins County over the past five years. The most frequently measured characteristic groups are Physical, Inorganics, Major, Non-metals, Nutrient. Each measurement is a single sample analyzed for one characteristic (E. coli, pH, dissolved oxygen, etc.). High monitoring density means more scientific evidence behind any reported signal — it does not by itself indicate water quality.
How does Hopkins County water compare to the Texas average?
Hopkins County's SDWIS water quality score of 50.5/100 is higher than the Texas state average of 30.4. The average water quality grade across Texas is F, based on data from 254 counties with available SDWIS data.
Is tap water safe to drink in Hopkins County?
Based on EPA SDWIS data, Hopkins County has a water quality grade of D (50.5/100). This indicates below-average compliance with significant violations. Residents may want to consider home water filtration or independent testing. The grade speaks to the public water system, not the watershed — for watershed-level concerns, see the Watershed Health zone. For the most up-to-date information, contact your local water utility or review your Consumer Confidence Report (CCR).
Why does Hopkins County have so many water violations?
Hopkins County has 7 health-based drinking water violations on record from the EPA SDWIS database. A higher violation count can result from aging infrastructure, underfunded water utilities, agricultural runoff contamination, or industrial pollution. Counties with more water systems may also see more violations simply due to scale. Residents concerned about water quality should consider independent water testing and home filtration systems.
How does Hopkins County rank for water quality in Texas?
Hopkins County ranks #58 out of 254 counties in Texas by SDWIS water quality score (1 = best). With a score of 50.5/100, it falls in the top third of counties statewide. The ranking reflects EPA SDWIS compliance only — not watershed impairment, monitoring density, or streamflow, which are tracked separately on this page.

Data Sources

Drinking-water compliance data from the EPA Safe Drinking Water Information System (SDWIS) via the ECHO enforcement database. Scores reflect compliance history and health-based violation counts.

Water-quality monitoring counts from the EPA Water Quality Portal (WQP) — federated USGS, EPA, and state agency sampling records over a rolling 5-year window.

Disclaimer: This data is informational only. It is not health, legal, or professional advice. For concerns about your specific water supply, contact your local water utility.

By Logan Johnson, Founder & Data EditorUpdated Reviewed by Logan Johnson, Founder & Data Editor