waterbycounty
EPA SDWIS

Skagway Municipality Water Quality

Skagway Municipality, Alaska

Water Grade

N/A

Water Score

N/A

Violations

N/A

State Rank

N/A

EPA SDWIS Compliance

Drinking Water Quality

Water Advisory: Skagway Municipality

Water Verdict

Skagway Municipality does not have sufficient EPA SDWIS water quality data to determine an overall assessment. Residents should contact their local water utility for the most recent Consumer Confidence Report.

Violation Context

Health-based violation data is not available for Skagway Municipality. EPA health violations occur when water systems exceed allowable contaminant levels or fail to meet treatment requirements. Residents should request the latest Consumer Confidence Report from their water provider.

Consumer Guidance

Residents of Skagway Municipality should obtain the annual Consumer Confidence Report from their water utility, which lists detected contaminants and any violations. Even without available data, using a NSF-certified water filter can provide additional peace of mind for drinking water.

Regional Context

State-level water quality comparison data is not available for Skagway Municipality. When data is available, this section will show how the county's water quality compares to other counties in Alaska.

Clean Water Act §303(d)

Watershed Health

Impaired Water Bodies

0.0%

0 of 3 assessed

Mostly healthy

Top Impairment Causes

No specific impairment causes reported for this county's assessed water bodies.

Source: EPA ATTAINS · Reporting cycle 2022

Impairment is determined under the Clean Water Act §303(d): a water body is impaired when it fails to meet state-defined quality standards for designated uses (drinking, recreation, aquatic life). Assessment coverage varies by state — counties without assessed water bodies are not shown.

Past 5 years

Water Quality Monitoring

Monitoring Sites

21

Active in the past 5 years

Measurements Recorded

3.0K

2,994 total readings

Most Measured

  • Physical
  • Microbiological
  • Inorganics, Minor, Metals

Categories measured most frequently

Data from the EPA Water Quality Portal (WQP), aggregating monitoring records from federal, state, and tribal sources. Each measurement represents a single sample analyzed for a specific characteristic (e.g., E. coli, pH, dissolved oxygen, nitrogen).

Live USGS Streamgage

River & Stream Conditions

Current Discharge

1,020cfs

May 14, 7:00 PM UTC

vs Long-Term Average

82%

Below typical

Primary Streamgage

TAIYA R NR SKAGWAY AK

USGS site
15056210
Drainage area
178 sq mi
Long-term mean
1,249 cfs

One representative streamgage (the one with the largest drainage area in the county). Many counties have multiple gauges — this view summarizes the primary one. The long-term mean is the full-record annual average; "% of typical" compares the latest reading against that average.

Improve your water quality at home

Berkey filters remove 99.9%+ of contaminants from tap water.

Shop Berkey →

Sponsored

Test your tap water

Tap Score provides professional mail-in water testing.

Get Tested →

Frequently Asked Questions

What is the water quality in Skagway Municipality, Alaska?
Skagway Municipality, Alaska has a drinking-water quality grade of N/A with a score of N/A/100, based on EPA SDWIS compliance data. Compliance data is currently unavailable. Watershed health, monitoring records, and live streamflow are reported separately on this page.
Are there any water violations in Skagway Municipality?
Violation data for Skagway Municipality is not currently available. Health-based violations indicate instances where contaminant levels exceeded EPA Maximum Contaminant Levels (MCLs).
How healthy are the watersheds in Skagway Municipality?
EPA ATTAINS assessments under Clean Water Act §303(d) indicate 0.0% of Skagway Municipality's 3 assessed water bodies are classified as impaired (0 impaired). Impairment means the water body fails to meet state quality standards for at least one designated use — drinking water source, recreation, aquatic life, or fish consumption. Note: watershed impairment doesn't always translate to tap-water issues; treatment plants can remove most regulated contaminants.
How much water-quality monitoring happens in Skagway Municipality?
EPA's Water Quality Portal records 2,994 measurements from 21 monitoring sites in Skagway Municipality over the past five years. The most frequently measured characteristic groups are Physical, Microbiological, Inorganics, Minor, Metals. Each measurement is a single sample analyzed for one characteristic (E. coli, pH, dissolved oxygen, etc.). High monitoring density means more scientific evidence behind any reported signal — it does not by itself indicate water quality.
What's happening with rivers in Skagway Municipality right now?
Skagway Municipality's primary USGS streamgage on the TAIYA R is currently reading 1,020 cubic feet per second — 82% of the long-term mean of 1,249.15 cfs. Flow is within typical range for this gauge. For genuine real-time data, visit waterdata.usgs.gov.
How does Skagway Municipality water compare to the Alaska average?
Skagway Municipality's SDWIS water quality score of N/A/100 is not available for comparison. The average water quality grade across Alaska is F, based on data from 22 counties with available SDWIS data.
Is tap water safe to drink in Skagway Municipality?
Based on EPA SDWIS data, Skagway Municipality has a water quality grade of N/A (N/A/100). Insufficient data is available to fully assess compliance. The grade speaks to the public water system, not the watershed — for watershed-level concerns, see the Watershed Health zone. For the most up-to-date information, contact your local water utility or review your Consumer Confidence Report (CCR).
Does Skagway Municipality have clean drinking water?
Skagway Municipality has no reported health-based drinking water violations according to EPA records. With a water quality score of N/A/100 and grade N/A, the county's drinking water has had some compliance issues but continues to be monitored. Note: drinking-water compliance speaks to the public water system, not necessarily to the watershed itself — check the Watershed Health zone for ATTAINS §303(d) data.
How is water quality measured?
WaterByCounty layers four federal datasets per county. The A–F drinking-water grade comes from EPA SDWIS (Safe Drinking Water Act compliance, 5-year violation lookback). The Watershed Health zone surfaces EPA ATTAINS §303(d) impairment data. The Monitoring zone summarizes EPA Water Quality Portal records. The Streamflow zone reports the latest USGS NWIS reading from the county's primary streamgage. Each is reported separately so you can see where the water is actually weakest.

Data Sources

Drinking-water compliance data from the EPA Safe Drinking Water Information System (SDWIS) via the ECHO enforcement database. Scores reflect compliance history and health-based violation counts.

Watershed health and impaired-waterway data from the EPA ATTAINS Clean Water Act §303(d) assessments — state-reported, EPA-finalized.

Water-quality monitoring counts from the EPA Water Quality Portal (WQP) — federated USGS, EPA, and state agency sampling records over a rolling 5-year window.

Live streamflow from the USGS National Water Information System (NWIS) — continuous discharge measurements from the largest-drainage gauge in each county, compared against the full-record long-term annual mean.

Disclaimer: This data is informational only. It is not health, legal, or professional advice. For concerns about your specific water supply, contact your local water utility.

By Logan Johnson, Founder & Data EditorUpdated Reviewed by Logan Johnson, Founder & Data Editor

Explore more data for Skagway Municipality

Property TaxCost of LivingCrime RateIncomeHealthSchoolsDisaster RiskWeatherCounty Score