waterbycounty
EPA SDWIS

Campbell County Water Quality

Campbell County, Kentucky

Water Grade

N/A

Water Score

N/A

Violations

N/A

State Rank

N/A

EPA SDWIS Compliance

Drinking Water Quality

Water Advisory: Campbell County

Water Verdict

Campbell County does not have sufficient EPA SDWIS water quality data to determine an overall assessment. Residents should contact their local water utility for the most recent Consumer Confidence Report.

Violation Context

Health-based violation data is not available for Campbell County. EPA health violations occur when water systems exceed allowable contaminant levels or fail to meet treatment requirements. Residents should request the latest Consumer Confidence Report from their water provider.

Consumer Guidance

Residents of Campbell County should obtain the annual Consumer Confidence Report from their water utility, which lists detected contaminants and any violations. Even without available data, using a NSF-certified water filter can provide additional peace of mind for drinking water.

Regional Context

State-level water quality comparison data is not available for Campbell County. When data is available, this section will show how the county's water quality compares to other counties in Kentucky.

Clean Water Act §303(d)

Watershed Health

Impaired Water Bodies

0.0%

0 of 1 assessed

Mostly healthy

Top Impairment Causes

No specific impairment causes reported for this county's assessed water bodies.

Source: EPA ATTAINS · Reporting cycle 2022

Impairment is determined under the Clean Water Act §303(d): a water body is impaired when it fails to meet state-defined quality standards for designated uses (drinking, recreation, aquatic life). Assessment coverage varies by state — counties without assessed water bodies are not shown.

Past 5 years

Water Quality Monitoring

Monitoring Sites

10

Active in the past 5 years

Measurements Recorded

4.0K

3,983 total readings

Most Measured

  • Physical
  • Nutrient
  • Inorganics, Major, Non-metals

Categories measured most frequently

Data from the EPA Water Quality Portal (WQP), aggregating monitoring records from federal, state, and tribal sources. Each measurement represents a single sample analyzed for a specific characteristic (e.g., E. coli, pH, dissolved oxygen, nitrogen).

Live USGS Streamgage

River & Stream Conditions

Current Discharge

462cfs

May 14, 6:30 PM UTC

vs Long-Term Average

8%

Well below typical

Primary Streamgage

LICKING RIVER AT HWY 536 NEAR ALEXANDRIA, KY

USGS site
03254520
Drainage area
3,593 sq mi
Long-term mean
5,616 cfs

One representative streamgage (the one with the largest drainage area in the county). Many counties have multiple gauges — this view summarizes the primary one. The long-term mean is the full-record annual average; "% of typical" compares the latest reading against that average.

Improve your water quality at home

Berkey filters remove 99.9%+ of contaminants from tap water.

Shop Berkey →

Sponsored

Test your tap water

Tap Score provides professional mail-in water testing.

Get Tested →

Frequently Asked Questions

What is the water quality in Campbell County, Kentucky?
Campbell County, Kentucky has a drinking-water quality grade of N/A with a score of N/A/100, based on EPA SDWIS compliance data. Compliance data is currently unavailable. Watershed health, monitoring records, and live streamflow are reported separately on this page.
Are there any water violations in Campbell County?
Violation data for Campbell County is not currently available. Health-based violations indicate instances where contaminant levels exceeded EPA Maximum Contaminant Levels (MCLs).
How healthy are the watersheds in Campbell County?
EPA ATTAINS assessments under Clean Water Act §303(d) indicate 0.0% of Campbell County's 1 assessed water bodies are classified as impaired (0 impaired). Impairment means the water body fails to meet state quality standards for at least one designated use — drinking water source, recreation, aquatic life, or fish consumption. Note: watershed impairment doesn't always translate to tap-water issues; treatment plants can remove most regulated contaminants.
How much water-quality monitoring happens in Campbell County?
EPA's Water Quality Portal records 3,983 measurements from 10 monitoring sites in Campbell County over the past five years. The most frequently measured characteristic groups are Physical, Nutrient, Inorganics, Major, Non-metals. Each measurement is a single sample analyzed for one characteristic (E. coli, pH, dissolved oxygen, etc.). High monitoring density means more scientific evidence behind any reported signal — it does not by itself indicate water quality.
What's happening with rivers in Campbell County right now?
Campbell County's primary USGS streamgage on the LICKING RIVER is currently reading 462 cubic feet per second — 8% of the long-term mean of 5,616.42 cfs. This is well below typical — often a signal of drought stress on source water. For genuine real-time data, visit waterdata.usgs.gov.
How does Campbell County water compare to the Kentucky average?
Campbell County's SDWIS water quality score of N/A/100 is not available for comparison. The average water quality grade across Kentucky is C, based on data from 118 counties with available SDWIS data.
Is tap water safe to drink in Campbell County?
Based on EPA SDWIS data, Campbell County has a water quality grade of N/A (N/A/100). Insufficient data is available to fully assess compliance. The grade speaks to the public water system, not the watershed — for watershed-level concerns, see the Watershed Health zone. For the most up-to-date information, contact your local water utility or review your Consumer Confidence Report (CCR).
Does Campbell County have clean drinking water?
Campbell County has no reported health-based drinking water violations according to EPA records. With a water quality score of N/A/100 and grade N/A, the county's drinking water has had some compliance issues but continues to be monitored. Note: drinking-water compliance speaks to the public water system, not necessarily to the watershed itself — check the Watershed Health zone for ATTAINS §303(d) data.
How is water quality measured?
WaterByCounty layers four federal datasets per county. The A–F drinking-water grade comes from EPA SDWIS (Safe Drinking Water Act compliance, 5-year violation lookback). The Watershed Health zone surfaces EPA ATTAINS §303(d) impairment data. The Monitoring zone summarizes EPA Water Quality Portal records. The Streamflow zone reports the latest USGS NWIS reading from the county's primary streamgage. Each is reported separately so you can see where the water is actually weakest.

Data Sources

Drinking-water compliance data from the EPA Safe Drinking Water Information System (SDWIS) via the ECHO enforcement database. Scores reflect compliance history and health-based violation counts.

Watershed health and impaired-waterway data from the EPA ATTAINS Clean Water Act §303(d) assessments — state-reported, EPA-finalized.

Water-quality monitoring counts from the EPA Water Quality Portal (WQP) — federated USGS, EPA, and state agency sampling records over a rolling 5-year window.

Live streamflow from the USGS National Water Information System (NWIS) — continuous discharge measurements from the largest-drainage gauge in each county, compared against the full-record long-term annual mean.

Disclaimer: This data is informational only. It is not health, legal, or professional advice. For concerns about your specific water supply, contact your local water utility.

By Logan Johnson, Founder & Data EditorUpdated Reviewed by Logan Johnson, Founder & Data Editor

Explore more data for Campbell County

Property TaxCost of LivingCrime RateIncomeHealthSchoolsDisaster RiskWeatherCounty Score