waterbycounty
EPA SDWIS

Monroe County Water Quality

Monroe County, Kentucky

Water Grade

F

Water Score

22.8

Violations

14

State Rank

#107

of 118 (1 = best)

EPA SDWIS Compliance

Drinking Water Quality

Water Quality Grade

F

Based on EPA compliance history and violation data

Water Score

22.8/100

Higher = better quality

Health Violations

14

Health-based violations

Violation Rate

103.7%

Systems with violations

Water Advisory: Monroe County

Water Verdict

Monroe County receives a poor water quality assessment with a grade of F and a score of 22.8 out of 100. The water supply has documented quality issues. Residents are strongly encouraged to use filtered or bottled water for drinking and to stay informed about utility improvement plans.

Violation Context

Monroe County has recorded 14 health-based violations, indicating multiple instances where federal contaminant limits or treatment requirements were not met. At 103.7 violations per 1,000 residents, this rate is high and signals significant water quality management issues.

Consumer Guidance

Residents of Monroe County are advised to use filtered or bottled water for drinking and cooking until water quality improves. A reverse-osmosis or activated-carbon filter certified to remove the contaminants listed in the utility's Consumer Confidence Report is recommended. With 14 recorded health violations, staying informed about utility communications and boil-water notices is especially important. For long-term peace of mind, request your utility's latest Consumer Confidence Report and consider independent water testing if you have specific health concerns.

Regional Context

Monroe County has poorer water quality than the average county in Kentucky. Its water score is 41.4 points lower than the state average, suggesting more challenges with contamination control or infrastructure than neighboring counties.

Clean Water Act §303(d)

Watershed Health

Impaired Water Bodies

0.0%

0 of 4 assessed

Mostly healthy

Top Impairment Causes

No specific impairment causes reported for this county's assessed water bodies.

Source: EPA ATTAINS · Reporting cycle 2022

Impairment is determined under the Clean Water Act §303(d): a water body is impaired when it fails to meet state-defined quality standards for designated uses (drinking, recreation, aquatic life). Assessment coverage varies by state — counties without assessed water bodies are not shown.

Past 5 years

Water Quality Monitoring

Monitoring Sites

2

Active in the past 5 years

Measurements Recorded

1.3K

1,290 total readings

Most Measured

  • Inorganics, Minor, Metals
  • Physical
  • Nutrient

Categories measured most frequently

Data from the EPA Water Quality Portal (WQP), aggregating monitoring records from federal, state, and tribal sources. Each measurement represents a single sample analyzed for a specific characteristic (e.g., E. coli, pH, dissolved oxygen, nitrogen).

Improve your water quality at home

Berkey filters remove 99.9%+ of contaminants from tap water.

Shop Berkey →

Sponsored

Test your tap water

Tap Score provides professional mail-in water testing.

Get Tested →

Frequently Asked Questions

What is the water quality in Monroe County, Kentucky?
Monroe County, Kentucky has a drinking-water quality grade of F with a score of 22.8/100, based on EPA SDWIS compliance data. The county has 14 health-based drinking water violations over the past 5 years. Watershed health, monitoring records, and live streamflow are reported separately on this page.
Are there any water violations in Monroe County?
Monroe County has 14 health-based drinking water violations recorded by the EPA over the past 5 years. Health-based violations indicate instances where contaminant levels exceeded EPA Maximum Contaminant Levels (MCLs). Violations may have been resolved — check with your local water utility for current status.
How healthy are the watersheds in Monroe County?
EPA ATTAINS assessments under Clean Water Act §303(d) indicate 0.0% of Monroe County's 4 assessed water bodies are classified as impaired (0 impaired). Impairment means the water body fails to meet state quality standards for at least one designated use — drinking water source, recreation, aquatic life, or fish consumption. Note: watershed impairment doesn't always translate to tap-water issues; treatment plants can remove most regulated contaminants.
How much water-quality monitoring happens in Monroe County?
EPA's Water Quality Portal records 1,290 measurements from 2 monitoring sites in Monroe County over the past five years. The most frequently measured characteristic groups are Inorganics, Minor, Metals, Physical, Nutrient. Each measurement is a single sample analyzed for one characteristic (E. coli, pH, dissolved oxygen, etc.). High monitoring density means more scientific evidence behind any reported signal — it does not by itself indicate water quality.
How does Monroe County water compare to the Kentucky average?
Monroe County's SDWIS water quality score of 22.8/100 is lower than the Kentucky state average of 64.2. The average water quality grade across Kentucky is C, based on data from 118 counties with available SDWIS data.
Is tap water safe to drink in Monroe County?
Based on EPA SDWIS data, Monroe County has a water quality grade of F (22.8/100). This indicates below-average compliance with significant violations. Residents may want to consider home water filtration or independent testing. The grade speaks to the public water system, not the watershed — for watershed-level concerns, see the Watershed Health zone. For the most up-to-date information, contact your local water utility or review your Consumer Confidence Report (CCR).
Why does Monroe County have so many water violations?
Monroe County has 14 health-based drinking water violations on record from the EPA SDWIS database. A higher violation count can result from aging infrastructure, underfunded water utilities, agricultural runoff contamination, or industrial pollution. Counties with more water systems may also see more violations simply due to scale. Residents concerned about water quality should consider independent water testing and home filtration systems.
How does Monroe County rank for water quality in Kentucky?
Monroe County ranks #107 out of 118 counties in Kentucky by SDWIS water quality score (1 = best). With a score of 22.8/100, it falls in the bottom third of counties statewide. The ranking reflects EPA SDWIS compliance only — not watershed impairment, monitoring density, or streamflow, which are tracked separately on this page.

Counties with Similar Water Quality

Lyon County

Kentucky

F

21.5

Water score

Crittenden County

Kentucky

F

20.0

Water score

Muhlenberg County

Kentucky

F

25.8

Water score

Data Sources

Drinking-water compliance data from the EPA Safe Drinking Water Information System (SDWIS) via the ECHO enforcement database. Scores reflect compliance history and health-based violation counts.

Watershed health and impaired-waterway data from the EPA ATTAINS Clean Water Act §303(d) assessments — state-reported, EPA-finalized.

Water-quality monitoring counts from the EPA Water Quality Portal (WQP) — federated USGS, EPA, and state agency sampling records over a rolling 5-year window.

Disclaimer: This data is informational only. It is not health, legal, or professional advice. For concerns about your specific water supply, contact your local water utility.

By Logan Johnson, Founder & Data EditorUpdated Reviewed by Logan Johnson, Founder & Data Editor

Explore more data for Monroe County

Property TaxCost of LivingCrime RateIncomeHealthSchoolsDisaster RiskWeatherCounty Score