waterbycounty
EPA SDWIS

Pike County Water Quality

Pike County, Kentucky

Water Grade

F

Water Score

31.0

Violations

34

State Rank

#100

of 118 (1 = best)

EPA SDWIS Compliance

Drinking Water Quality

Water Quality Grade

F

Based on EPA compliance history and violation data

Water Score

31/100

Higher = better quality

Health Violations

34

Health-based violations

Violation Rate

61.4%

Systems with violations

Water Advisory: Pike County

Water Verdict

Pike County receives a poor water quality assessment with a grade of F and a score of 31.0 out of 100. The water supply has documented quality issues. Residents are strongly encouraged to use filtered or bottled water for drinking and to stay informed about utility improvement plans.

Violation Context

Pike County has recorded 34 health-based violations, indicating multiple instances where federal contaminant limits or treatment requirements were not met. At 61.4 violations per 1,000 residents, this rate is high and signals significant water quality management issues.

Consumer Guidance

Residents of Pike County are advised to use filtered or bottled water for drinking and cooking until water quality improves. A reverse-osmosis or activated-carbon filter certified to remove the contaminants listed in the utility's Consumer Confidence Report is recommended. With 34 recorded health violations, staying informed about utility communications and boil-water notices is especially important. For long-term peace of mind, request your utility's latest Consumer Confidence Report and consider independent water testing if you have specific health concerns.

Regional Context

Pike County has poorer water quality than the average county in Kentucky. Its water score is 33.2 points lower than the state average, suggesting more challenges with contamination control or infrastructure than neighboring counties.

Past 5 years

Water Quality Monitoring

Monitoring Sites

11

Active in the past 5 years

Measurements Recorded

9.8K

9,779 total readings

Most Measured

  • Physical
  • Inorganics, Minor, Metals
  • Nutrient

Categories measured most frequently

Data from the EPA Water Quality Portal (WQP), aggregating monitoring records from federal, state, and tribal sources. Each measurement represents a single sample analyzed for a specific characteristic (e.g., E. coli, pH, dissolved oxygen, nitrogen).

Live USGS Streamgage

River & Stream Conditions

Current Discharge

273cfs

May 14, 6:30 PM UTC

vs Long-Term Average

18%

Well below typical

Primary Streamgage

LEVISA FORK AT PIKEVILLE, KY

USGS site
03209500
Drainage area
1,232 sq mi
Long-term mean
1,554 cfs

One representative streamgage (the one with the largest drainage area in the county). Many counties have multiple gauges — this view summarizes the primary one. The long-term mean is the full-record annual average; "% of typical" compares the latest reading against that average.

Improve your water quality at home

Berkey filters remove 99.9%+ of contaminants from tap water.

Shop Berkey →

Sponsored

Test your tap water

Tap Score provides professional mail-in water testing.

Get Tested →

Frequently Asked Questions

What is the water quality in Pike County, Kentucky?
Pike County, Kentucky has a drinking-water quality grade of F with a score of 31.0/100, based on EPA SDWIS compliance data. The county has 34 health-based drinking water violations over the past 5 years. Watershed health, monitoring records, and live streamflow are reported separately on this page.
Are there any water violations in Pike County?
Pike County has 34 health-based drinking water violations recorded by the EPA over the past 5 years. Health-based violations indicate instances where contaminant levels exceeded EPA Maximum Contaminant Levels (MCLs). Violations may have been resolved — check with your local water utility for current status.
How much water-quality monitoring happens in Pike County?
EPA's Water Quality Portal records 9,779 measurements from 11 monitoring sites in Pike County over the past five years. The most frequently measured characteristic groups are Physical, Inorganics, Minor, Metals, Nutrient. Each measurement is a single sample analyzed for one characteristic (E. coli, pH, dissolved oxygen, etc.). High monitoring density means more scientific evidence behind any reported signal — it does not by itself indicate water quality.
What's happening with rivers in Pike County right now?
Pike County's primary USGS streamgage on the LEVISA FORK is currently reading 273 cubic feet per second — 18% of the long-term mean of 1,553.7 cfs. This is well below typical — often a signal of drought stress on source water. For genuine real-time data, visit waterdata.usgs.gov.
How does Pike County water compare to the Kentucky average?
Pike County's SDWIS water quality score of 31.0/100 is lower than the Kentucky state average of 64.2. The average water quality grade across Kentucky is C, based on data from 118 counties with available SDWIS data.
Is tap water safe to drink in Pike County?
Based on EPA SDWIS data, Pike County has a water quality grade of F (31.0/100). This indicates below-average compliance with significant violations. Residents may want to consider home water filtration or independent testing. The grade speaks to the public water system, not the watershed — for watershed-level concerns, see the Watershed Health zone. For the most up-to-date information, contact your local water utility or review your Consumer Confidence Report (CCR).
Why does Pike County have so many water violations?
Pike County has 34 health-based drinking water violations on record from the EPA SDWIS database. A higher violation count can result from aging infrastructure, underfunded water utilities, agricultural runoff contamination, or industrial pollution. Counties with more water systems may also see more violations simply due to scale. Residents concerned about water quality should consider independent water testing and home filtration systems.
How does Pike County rank for water quality in Kentucky?
Pike County ranks #100 out of 118 counties in Kentucky by SDWIS water quality score (1 = best). With a score of 31.0/100, it falls in the bottom third of counties statewide. The ranking reflects EPA SDWIS compliance only — not watershed impairment, monitoring density, or streamflow, which are tracked separately on this page.

Counties with Similar Water Quality

Martin County

Kentucky

F

32.5

Water score

Bath County

Kentucky

F

29.0

Water score

Jackson County

Kentucky

F

33.0

Water score

Data Sources

Drinking-water compliance data from the EPA Safe Drinking Water Information System (SDWIS) via the ECHO enforcement database. Scores reflect compliance history and health-based violation counts.

Water-quality monitoring counts from the EPA Water Quality Portal (WQP) — federated USGS, EPA, and state agency sampling records over a rolling 5-year window.

Live streamflow from the USGS National Water Information System (NWIS) — continuous discharge measurements from the largest-drainage gauge in each county, compared against the full-record long-term annual mean.

Disclaimer: This data is informational only. It is not health, legal, or professional advice. For concerns about your specific water supply, contact your local water utility.

By Logan Johnson, Founder & Data EditorUpdated Reviewed by Logan Johnson, Founder & Data Editor

Explore more data for Pike County

Property TaxCost of LivingCrime RateIncomeHealthSchoolsDisaster RiskWeatherCounty Score